Soap Pop Silicone Soap Mold

Get in the spirit of Summer with this amazing soap mold from Crafter's Choice! The Soap Pop Silicone Soap Mold is the perfect way to make the soap version of those tasty treats and is the perfect way to show off your favourite embeds, aromas and colours!

Material: Food Grade SiliconeMaximum Product Pour Temp: 500ºFMakes (6) Soap Pop Bars

Melt & Pour Soap: Pour melted soap into silicone mold cavities. Place lid on top of soap, and then insert popsicle sticks into each hole. Allow soap to cool at room temperature until hard. Carefully remove lid. Remove soap from mold by gently pulling the sides away from the soap, and then push on the bottom of the mold until the soap starts to release. Grab hold of the soap and carefully pull out of the mold. DO NOT PULL FROM STICKS.Cold Process Soap: Pour soap at trace into the mold cavities. Place lid on top of soap, and then insert popsicle sticks into each hole. After at least 24 hours, remove lid and gently pull silicone mold to loosen its grip on the soap. Gently push on the bottom of mold until the soap starts to release. Grab hold of the soap with a gloved hand, and allow soap to cure for 4-8 weeks. Note that some cp soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster. DO NOT PULL FROM STICKS.Hot Process Soap: Scoop hot process soap into mold cavities. Gently tap the mold onto the counter to remove air pockets. Place lid on top of soap, and then insert popsicle sticks into each hole. Allow soap to cool and harden. (This can take up to 48 hours.) Carefully remove soap from mold by gently pulling the sides away from the soap, and then push on the bottom of the mold until the soap starts to release. Grab hold of the soap and carefully pull out of the mold. DO NOT PULL FROM STICKS.Lotion Bars: Pour melted lotion bar mixture into mold cavities. Place lid on top of soap, and then insert popsicle sticks into each hole. Allow mixture to solidify. Carefully remove lotion bars from mold by gently pulling the sides away from the lotion bars, and then push on the bottom of the mold until the lotion bars starts to release. Grab hold of lotion bar and carefully pull out of mold. DO NOT PULL FROM STICKS.Care: Hand wash in warm sudsy water.