Rectangle Euro Cavity Silicone Soap Mold
The Rectangle Euro Cavity Silicone Soap Mold is the modern version of a classic soap design. Allowing you to create 15 bars of soap at once, the soap made are slightly narrower and thicker then a traditional bar.
Material: Food Grade Silicone
Maximum Product Pour Temp: 500ºF
Makes (15) Individual Bars
Approximate Bar Weight: 4.8 oz
Measures: 2.8" x 1.8" x 1.5" Deep
Makes (15) 4.8 oz. Bars
Bar Dimensions: 2.8" x 1.8" x 1.5" deep
Melt & Pour Soap: Pour melted soap into silicone mold cavities. Allow soap to cool at room temperature until hard. Carefully remove soap from mold by gently pulling the sides away from the soap, and then push on the bottom of the mold until the soap starts to release. Grab hold of the soap and carefully pull out of the mold.
Cold Process Soap: Pour soap at trace into the mold cavities. After at least 24 hours, gently pull silicone mold to loosen its grip on the soap. Flip mold over onto a clean surface and gently push on the bottom of mold until the soap starts to release. Grab hold of the soap with a gloved hand, and allow soap to cure for 4-8 weeks. Note that some cold process soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster.
Lotion Bars: Pour melted lotion bar mixture into mold cavities. Allow mixture to solidify. Carefully remove lotion bars from mold by gently pulling the sides away from the lotion bars, and then push on the bottom of the mold until the lotion bars starts to release. Grab hold of lotion bar and carefully pull out of mold.
Care: Hand wash in warm sudsy water.